بهبود میزان خطینگی تقویت‌کننده توان با ترکیب روش‌های پیش‌خور و دوهرتی

[1] F. Raab, P. Asbeck, S. Cripps, P.Kenington, Z. Popovic, N. Pothecary, "Power Amplifiers and Transmitters for RF and Microwave," IEEE Trans. Microw. Theory Tech, vol. 50, p. 814–826, 2002.

[2] D. Lim, S. Heo and J. No, "An Overview of Oeak-to-Average Power Ratio Reduction Schemes for OFDM Signals," in Journal of Communications and Networks, vol. 11, no. 3, pp. 229-239, 2009.

[3] S. H. Han and J. H. Lee, "An Overview of Peak-to-Average Power Ratio Reduction Techniques For Multicarrier Transmission," in IEEE Wireless Communications, vol. 12, no. 2, pp. 56-65, 2005.

[4] W. H.Doherty, "A New High Efficiency Power Amplifier for Modulated Waves," Proc. IRE, vol. 24, pp. 1163-1182, 1936.

[5] B. Kim, J. Kim, I. Kim, and J. Cha, “The Doherty Power Amplifier,” IEEE Microw. Mag., vol. 7, no. 5, pp. 42–50, 2006.

[6] R. Quaglia, M. Pirola, and C. Ramella, "Offset Lines in Doherty Power Amplifiers: Analytical Demonstration and Design," IEEE Microw. Wireless Compon. Lett, Vols. 23,no. 2, pp. 93-95, 2013.

[7] A. Grebennikov and S. Bulja, "High-Efficiency Doherty Power Amplifiers: Historical Aspect and Modern Trends," Proc. IEEE, Vol. 100, no.12, pp. 3190-3219, Dec. 2012.

[8] Z. Zeinodin,Z.H. firoozeh and R. Bahadori, “Design and manufacturing a low-noise balanced amplifier based on HJFET transistors in the 9-11 GHz frequency band,” Journal of Electrical Engineering, University of Tabriz, Vol.47, No.1, pp 93-105, 2017.

[9] J. Yi, Y. Yang, M. Park, W. Kang and B. Kim, "Analog Predistortion Linearizer for High-Power RF Amplifiers," in IEEE Transactions on Microwave Theory and Techniques, vol. 48, no. 12, pp. 2709-2713, 2000.

[10] S. C. Cripps, “RF Power Amplifiers for Wireless Communications,” Norwood, MA: Artech House, 2006.

[11] J. Kim, B. Fehri, S. Boumaiza, and J. Wood, “Power Efficiency and Linearity Enhancement Using Optimized Asymmetrical Doherty Power Amplifiers,”IEEE Trans. Microw. Theory Tech., vol. 59, no. 2, pp. 425–434, 2011.

[12] L. C. Nunes, P. M. Cabral, and J. C. Pedro, “AM/PM Distortion in GaN Doherty Power Amplifiers,” inProc.IEEEMTT-SInt.Microwave Symp, pp. 1–4, 2014.

[13] L.Piazzon, R.Giofrè, R. Quaglia,V. Camarchia, M.Pirola, P.Colantonio, F. Giannini, and G. Ghione, “Effect of Load Modulation on Phase Distortion in Doherty Power  Amplifiers, ”IEEE Microw. Wireless Compon. Lett, vol. 24, no. 7, pp. 505–507, Jul. 2014.

[14] F. Abbasnezhad, M. Tayarani, A. Abrishamifar and E.J. Salmasi, “Improving the linearity characteristics of GaN power amplifiers based on second harmonic signal injection,” Journal of Electrical Engineering, University of Tabriz, Vol.51, No.4, pp 403-412, 2021.

[15] D. Jung, H. Zhao and H. Wang, "A CMOS Highly Linear Doherty Power Amplifier With Multigated Transistors," in IEEE Transactions on Microwave Theory and Techniques, vol. 67, no. 5, pp. 1883-1891, May 2019.

[16] J. M. Rubio, J. Fang, V. Camarchia, R. Quaglia, M. Pirola, and G. Ghione, “3–3.6 GHz wideband GaN Doherty power amplifier exploiting output compensation stages,” IEEE Trans. Microw. Theory Techn., vol. 60, no. 8, pp. 2543–2548, Aug. 2012.

[17] X. Fang and K.-M. M. Cheng, “Broadband, wide efficiency range,Doherty amplifier design using frequency-varying complex combining load,” in IEEE MTT-S Int. Microw. Symp. Dig., Phoenix, AZ, USA, pp. 1–4, 2015.

[18] M. N. A. Abadi, H. Golestaneh, H. Sarbishaei, and S. Boumaiza, “Doherty power amplifier with extended bandwidth and improved linearizability under carrier-aggregated signal stimuli,” IEEE Microw. Wireless Compon. Lett., vol. 26, no. 5, pp. 358–360, 2016.

[19] Mohamed, S. Boumaiza, and R. Mansour, “Doherty power amplifier with enhanced efficiency at extended operating average power levels,” IEEE Trans. Microw. Theory Tech., vol. 61, no. 12, pp. 4179–4187, 2013.

[20] S. Zhao, Z. Tang, Y. Wu, and L. Bao, “Linearity improved Doherty power amplifier using coupled-lines and a capacitive load,” IEEE Microw. Wireless Compon. Lett., vol. 21, no. 4, pp. 221–223, 2011.

[21] R. Giofrè, L. Piazzon, P. Colantonio, and F. Giannini, “A Doherty architecture with high feasibility and defined bandwidth behavior,” IEEE Trans. Microw. Theory Tech., vol. 61, no. 9, pp. 3308–3317, Sep. 2013.

[22] D. Kang, Y. Cho, D. Kim, B. Park, J. Kim, and B. Kim, “Impact of nonlinear on HBT Doherty power amplifiers,” IEEE Trans. Microw. Theory Tech., vol. 61, no. 9, pp. 3298–3307, Sep. 2013.

[23] J. Park, D. Kim, C. Yoo, W. Lee, J. Yook, and C. Hahn, “Efficiency enhancement of the Doherty amplifier for 3.5 GHz WiMAX application using class-F circuitry,” Microw. Opt. Tech. Lett., vol. 52, no. 3, pp. 570–573, Mar. 2010.

[24] Y. Lee, M. Lee, S. Kam, and Y. Jeong, “Highly linear and efficient       asymmetrical Doherty power amplifiers with adaptively bias-controlled predistortion drivers,” in IEEE MTT-S Int. Microw. Symp. Dig., Boston, MA, USA, pp. 1393–1396, 2009.