شبیه سازی تأثیر محرک پلاسما بر حباب جدایش جریان هوا

[1]  Brunn A., Nitsche W., Active control of turbulent separated flows over slanted surfaces, Int. J. Heat and Fluid Flow, Vol. 27, pp 748–755, 2006.

[2]  Aholt J., Influence of Laminar Separation Bubbles on the Aerodynamic Characteristics of Elliptical Airfoils at Low Reynolds Numbers, Missouri Space Grant Consortium Student Reports and Abstracts, MOSGC, Columbia, MO, April 2009.

[3]  Lamballais E., Silvestrini J., and Laizet S., Direct numerical simulation of flow separation behind a rounded leading edge: Study of curvature effects, Int. J. Heat and Fluid Flow Vol. 31, pp. 295–306, 2010.

[4]  Kosinov A., Maslov A., and Shevelkov S., Experiments on the stability of supersonic laminar boundary layers, J. Fluid Mech., Vol. 219, pp. 621-633, 1990.

[5]  Post M.L., Plasma actuators for separation control on stationary and unstationary airfoils, Ph.D. thesis, University of Notre Dame, 2004.

[6]  Orlov D.M., Modeling and Simulation of Single Dielectric Barrier Discharge Plasma Actuators, Ph.D. Thesis, University of Notre Dame, 2006.

[7]  Jayaraman B., and Shyy W., Modeling of dielectric barrier discharge-induced fluid dynamics and heat transfer, Progress in Aerospace Sciences, vol. 44, pp. 139-191, 2008.

[8]  Matéo-Vélez J.C., Rogier F., Thivet F., and Degond P., Numerical Modeling of Plasma - Flow Interaction, ICCS 2006, Part II, LNCS 3992, pp. 1–9, 2006.

[9]  Zhang P.F., Liu A.B., and Wang J.J., Flow structures in flat plate boundary layer induced by pulsed plasma actuator, Sci. China Tech. Sci., Vol. 53, No. 10, pp. 2772−2782, 2010.

[10]             Sosa R., Artana G., and Moreau E., Stall control at high angle of attack with plasma sheet actuators, Experiments in Fluids, Vol. 42, pp. 143-167, 2007.

[11]             Sosa R., Artana, G., and Moreau, E., “Stall control at high angle of attack with plasma sheet actuators”, Experiments in Fluids, pp. 143-167, (2007)

[12]             Patel M.P., Ng T.T., Vasudevan S., Corke T.C., Post M.L., Mclaughlin T.E., and Suchomel C.F., Scaling effects of an aerodynamic plasma actuator, Journal of aircraft, Vol. 45, No. 1, pp. 223-236, 2008.

[13]             Owsenek B.L., and Seyed-Yagoobi J., Theoretical and experimental study of electrohydrodynamic heat transfer enhancement through wire-plate corona discharge, Journal of Heat Transfer, Vol. 119, No. 3, pp. 604-610, 1997.

[14]             Melcher J.R., Continuum electromechanics, Cambridge, Mass, MIT Press. 1981.

[15]             Miranda W.R., and Rezende A.L.T., Rans Models Applied In A Flow Over A Rounded Edge, 22nd International Congress of Mechanical Engineering (COBEM), November 3-7, Ribeirão Preto, SP, Brazil, 2013.

[16]             Suzen Y.B., and Huang P.G., Simulations of Flow Separation Control using Plasma Actuators, AIAA Paper 2006-887, 2006.

[17]             Suzen Y.B., Huang P.G., and Jacob J.D., and Ashpis D. E., Numerical simulation of plasma based flow control applications, AIAA Paper 2005-4633, 2005.

[18]             Enloe C.L., Mclaughlin T.E., Van Dyken R.D., Kachner K.D., Jumper E.J., Corke T.C., Post M.L., and Haddad O, Mechanisms and responses of a single dielectric barrier plasma actuator: geometric effects, AIAA J., Vol. 42, No. 3, pp. 595–604, 2004.

[19]             Bouchmal, A., Modeling of Dielectric-Barrier Discharge Actuator, M. Sc. Thesis, Delft University of Technology, 2011.

[20]             Jacob J.D., Ramakumar K., Anthony R., and Rivir R.B., Control of Laminar and Turbulent Shear Flows Using Plasma Actuators, 4th International Symposium on Turbulence and Shear Flow Phenomena Williamsburg, VA June 27–29, 2005.

[21]             Djilali N., and Gartshore I.S., Turbulent flow around a bluff rectangular plate. Part I: Experimental investigation, ASME J. Fluids Eng. Vol. 113, No. 1, pp. 51-59, 1991.

[22]             Kavousfar S., Esmaeilzadeh E., Mahdavy-Moghaddam H., Mirzaei M., Pouryoussefi S.H., Experimental Study of Plasma Actuator Effects on Flow Field Separation Bubble around Blunt Flat Plate, Journal of Applied Fluid Mechanics, Accepted in February 5^th 2015.